• Best of luck to the class of 2024 for their HSC exams. You got this!
    Let us know your thoughts on the HSC exams here
  • YOU can help the next generation of students in the community!
    Share your trial papers and notes on our Notes & Resources page
MedVision ad

3 point turn question (1 Viewer)

michaelb92

Member
Joined
Aug 24, 2009
Messages
38
Gender
Male
HSC
2010
in the driving test, are you meant to indicate left before doing a 3 point turn to pull to the left and then indicate right and continue? if not, what are you meant to do?
 

bregitta

Red is for Rad
Joined
Oct 6, 2006
Messages
188
Gender
Female
HSC
2007
Make sure you do a really obvious headcheck to the left as you pull over too. Even though there'll probably not be another car in sight...
 

michaelb92

Member
Joined
Aug 24, 2009
Messages
38
Gender
Male
HSC
2010
ok thanks guys, i got my p's
ended up not having to do a 3 point turn, the manoeuvres i had to do were just kerbside stop and reverse parallel park.
 

michaelb92

Member
Joined
Aug 24, 2009
Messages
38
Gender
Male
HSC
2010
what type of parking do they normally test?
i think you are most likely going to get a reverse parallel if they make you do a park

The driving test includes a number of manoeuvres including:
• Kerb side stop.
• Hill start.
• Three-point turn.
• Parking, reverse parallel, 90 degree or 45 degree,
front or rear to kerb (type depending on local availability).

that was taken off the guide to the driving test
 

Riet

Tomcat Pilot
Joined
Mar 9, 2006
Messages
3,622
Location
Miramar, CA
Gender
Male
HSC
2013
yeah kerb-side stop and reverse parallel is what I had to do, I think it's probably the most common. I did a three-point turn in that he asked me to park in a dead end street and then I had to turn around, I'm not sure if it was counted or whatever but I knew how to do one anyway.
 

kooltrainer

New Member
Joined
Jun 17, 2006
Messages
659
Gender
Male
HSC
2008
lucky i didnt need to do hill start... otherwise i would crash into the car behind me.. my handbrake is mental..
 

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top