MedVision ad

doing law as well (1 Viewer)

mikerobertsn

New Member
Joined
Jul 31, 2009
Messages
5
Gender
Male
HSC
2009
i just started doing a bachalor of engineering degree and saw how there are double degrees like b law and b ict, and the workload is only 4 units per semester the same as individually, execpt it takes u a year longer, i was wondering if its possible to combine a batchalor of engineering with a bachalor of laws in the same way.
 

ambermorn

Tic Tac addict.
Joined
Dec 19, 2007
Messages
632
Location
Hills District
Gender
Female
HSC
N/A
Unfortunately, no. There's a list of law degrees here: UWS: Law Courses

However, this does not stop you from taking law subjects as open electives (if your course has any), provided that you meet the prerequisites for those subjects.

It may not count toward being a major on your Engineering transcript, but it's a good way to figure out if you like law, and you'd be able to apply for advanced standing if you pursued a law degree later on.

Alternatively, there's a B Engineering Science/B Law course at UTS that you could transfer into. Cutoff is 97.9

http://www.eng.uts.edu.au/courses/undergraduate/BESBLaws.htm
 
Last edited:

melsc

Premium Member
Joined
Aug 17, 2004
Messages
6,365
Location
Chasing ambulances in the Inner West...
Gender
Female
HSC
2005
see on this page UWS: Bachelor of Laws (Non-graduate entry) where it says "A record of study equivalent to one year full-time study at Bachelor level from an approved University" does that mean i could do it next year.
That is so that you can transfer into a law degree from another degree. Thats a transfer from Eng to Law not combining the two.
You can't make anything a double degree, only those that the univesity's offer as double degrees. The reason it takes 1-2 extra year (s) rather than 3 is because they allow some of the law subjects to also count as non law ones. If you want to do both you should to eng for one year and then see if any uni offers eng/law (see what ambermom said above) and transfer into that.
 
Last edited:

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top